Solids control equipment is very important in oil exploration, the development trend of China's solid control equipment is very stable,solids control system is consist of a lot of equipment. Because of the high usage of solids control equipment, they often break down, now let's talk about the issue about the failure of solids control equipment parts,these problems causes and solutions .  

When the solids control equipment being used in drilling,the mud agitator is an often damaged equipment. The main reason is high fluid density, high viscosity, low power mixer, resulting overload of use and can not insist on continuous operation. If no timely maintenance,lubrication and unreasonable installation,they can also cause this phenomenon. So we need to pay attention when we maintaining and repairing the equipment, we must operate it in normal methods so that we can get normal efficiency.
 

Sometimes solids control equipment desander and desilter in swirling funnel will be blocked causing equipment can not be used, the reason is the use of unreasonable or shaker screen cloth damage, followed by addition Sand Pump and except water pipes mud pump not installed filters, large particles into the cyclone funnel debris caused by blocked. Therefore, we must ensure a reasonable installation location, the complete parts' installation.  

Solids control equipment shale shaker sometimes fails to run the drilling fluid, mainly because of the drilling fluid displacement is greater than the load of the shale shaker, drilling fluid viscosity is too high, a fine mesh sieve cloth, fluids leak does not survive, or the drilling fluid mixed large amounts of fiber material when leaking, it make influence of drilling fluid leak, it may be also because screen cloth don’t get cleaned when stopping the drilling rig recycling equipment , screen cloth get blocked by the dried drilling fluid. And only we pay attention on this problems in a timely manner in everyday use,these problems can not happen.